Milli-Q Direct 8 - Page 25

Milli-Q® Direct 8/16 System 25
Tubing, cables and power cord, Continued
Feed water
tubing to pipe
• Install the Inlet Strainer as shown here.
• Connect one end of the feed water tubing to the Inlet Strainer.
Reservoir
connections
The tubings from the Water System Ports 3 and 4 are connected to the Reservoir as
shown here.
NOTE:
The valve where the tubing from Port 3 is connected must be opened.
Powering the
system
•
Open the feed water source.
• Plug the power cord into the Water System.
• Plug the power cord into a source of electrical power.
•
The Main LCD shows a series of start-up screens.
Continued on next page