Milli-Q Direct 8 - Page 76

76 Milli-Q® Direct 8/16 System
Replacing the Progard® Cartridge and Vent Filter, Continued
Removing
Follow the steps below to remove the used Progard® Cartridge.
Step
Action
Diagram
1
Place the System into STANDBY
Mode.
2
Push the POD Plunger down
once to depressurise the System.
After water stops being
dispensed, push down the
POD Plunger again.
3
Open the System right door.
Remove the used Progard®
Cartridge.
4
In a few moments, the System
indicates that the Progard®
Cartridge is removed.
Continued on next page