– viii –
Tool lifting speed setting [UP SPEED] ....................................................... 3. 27
Change-over of jog steps [JOG STEP] ........................................................3. 27
Dummy cut [DUMMY CUT] ......................................................................3. 28
Mark detecting function [MARK DETECT] ............................................... 3. 29
Sorting [SORTING] ...................................................................................... 3. 37
mm/inch [MM/INCH] ..................................................................................3. 40
Sheet setting [SHEET SET] ........................................................................ 3. 41
Setup resetting [SETUP RESET]................................................................3. 41
CHAPTER 4 IN CASE OF TROUBLE ..................................... 4. 1
BEFORE TAKING A PHENOMENON AS A TROUBLE ................................4. 2
TROUBLE FOR WHICH ERROR MESSAGES ARE GIVEN ON THE LCD ..
4. 4
Displays under the remote mode..................................................................... 4. 6
APPENDIX........................................................................................ A. 1
CUTTER BLADE .................................................................................................. A. 2
Replacing the cutter blade .............................................................................. A. 2
Adjusting the cutter blade .............................................................................. A. 3
SAMPLE OF OUTPUT ......................................................................................... A. 4
Dump list ........................................................................................................ A. 4
List ................................................................................................................. A. 5
SPECIFICATIONS OF THE MAIN UNIT ......................................................... A. 6
To Next Page
Loading...
