– 3.10 –
Data clear
The device terminates cutting (plotting) of the current data, and starts cutting (plotting) of new data.
If you want to stop cutting (plotting) of the current data before the device completes it, you have to
clear the data received.
• After the execution of data clearance, the received data will remain in the receiver
buffer. It is, therefore, possible to cut (plot) the data in repetition using the plural
sheet cutting function.
Execute the data clearance and set the device in the remote mode. When the device receives new
data from the host computer, it will cut (plot) the new data.
Sheet feed
The sheet is fed by the length to be used.
In the case where a roll sheet is used or a long-dimension data is to be cut (plotted), the sheet has to
be fed by the length to be used to provide an allowance. In addition, displacement of the sheet can
be checked by feeding the sheet.
Press the
key. Press the or key to set the feed amount. When the key is
pressed, the sheet is fed from the origin.
Setting value
For “mm”: 0.1 m to 51.0 m (in increments of 0.1 m)
For “inch”: 1 to 167 feet (in increments of 1 ft.)
If the sheet is too short in length to enable feeding of the sheet by the specified length, the following
display will appear on the LCD.
If this display appears on the LCD, press any key to reset it.
• To interrupt the sheet feed, press the
key.
Then, the following display will appear on the LCD.
DATA CLEAR <ENT>
**
STOP : 0. 3m
**
**
STOP : 1. 6m
**
To Next Page
Loading...
