MIMAKI CG-60EX - Operation of Keys Corresponding to the Functions

– 3.4 –
Operation of keys corresponding to the functions
Functions are selected and entered by operating the corresponding keys as described below.
Functions invoked with specific keys
Local mode
Remote mode
CUT1 20 050 0.30
DATA CLEAR <ENT>
SHEET FEED <ENT>
-- HOLD --
TOOL
SELECT
DATA
CLEAR
AUTO
FEED
ENTER
HOLD
REMOTE
LOCAL
ENTER
HOLD
ENTER
HOLD
TOOL
SELECT
TOOL
SELECT
TOOL
SELECT
TOOL
SELECT
TOOL
SELECT
CUT2 20 080 0.30
CUT3 05 150 0.30
TOOL
SELECT
TOOL
SELECT
CUT4 20 060 0.30
CUT5 20 070 0.30
PEN 40 060
PIN 40 080 0.30P
HALF 20 050 0.30
ENTER
HOLD
Input settings.
Data clear
Sheet feed
Input tie length by which
the device feeds the sheet.
Hold function
Tool selection/tool conditions
SPEED
PRESSURE
OFFSET
Plotting conditions
Pouncing conditions (in the case where
the pouncing function is set to the ON state)
Cutting conditions (half cut)
(in the case where the HALF CUT
is set to the ON state)
CUT1 ** REMOTE **
CUT1 20 050 0.30