– 2.25 –
The sheet width is detected
first, then the sheet length is
detected by feeding the sheet
forward and backward.
A leaf sheet is
loaded to the front
face of the device.
The sheet width is detected
first, then the sheet length is
detected by feeding the sheet
forward and backward.
The sheet width is detected
first, then front end of the
sheet is detected.
A roll sheet is
loaded to the front
face of the device.
The sheet width is detected
first, then rear end of the
sheet is detected.
A roll sheet is A leaf sheet is Only the sheet
Key loaded to the rear loaded to the rear width is
face of the device. face of the device. detected.
The device detects a sheet of media in the five different methods as shown below.
This side
OriginOrigin
This sideThis side
Origin
Origin
Origin
Detecting
method
Example of
display after the
sheet detection
Key
Detecting
method
Example of
display after the
sheet detection
Only the sheet width is
detected.
A
B
END
* In the case where the detected dimension is 3 m or more, the display “ * * * * ”
will appear on the LCD.
• In the case where a long sheet of media is used or a drawn-out sheet is used from
its middle area, the sheet detection will require an extended period of time. In
such a case, the detection time can be reduced by detecting only the sheet width.
A =
****
B = 123 A =
****
B = 123
A =
****
B = 123
A = 567 B = 123
A = 567 B = 123
BB
A
B
B
To Next Page
Loading...
