– 4.5 –
An inappropriate operation was
performed on the control panel.
The device has executed the plural
sheets cutting to find that there is no
data in the receiver buffer.
The amount of received data is too
large for the device to perform the
plural sheets cutting.
The sheet is too short in terms of the
feeding direction.
The device has executed an
improper operation while it is put on
hold.
The device has failed to detect a
registration mark.
The sheet feeding motor has been
applied with an extra load.
The carriage driving motor has been
applied with an extra load.
An overcurrent error in the motor in
the lengthwise direction of the sheet
has been detected.
An overcurrent error in the motor in
the widthwise direction of the sheet
has been detected.
The device has failed to detect the
sheet size.
Error message Cause Action
Perform the correct operation.
Refer to the explanation of the plural
sheets cutting function. (See page
2.12)
Refer to the explanation of the plural
sheets cutting function. (See page
3.13)
Use a longer sheet.
Press the key to cut the
remaining data or clear it. (See page
3.10.)
• Check up the procedure you have
taken to detect the mark.
If you have followed the correct
procedure, contact your
distributor.
•A mark that is not black is printed
against white background.
• Check whether or not the sheet is
curling up.
Turn off the power to the device
once. Then, re-turn it on. If the
same error message re-appears on
the LCD, contact your distributor.
ERR30 OPERATION
ERR31 NO DATA
ERR32 DATAtooBIG
ERR33 SHEET SIZE
ERR34 DAT REMAIN
ERR36 MARKdetect
ERR40 MOTOR A
ERR41 MOTOR B
ERR42 A CURRENT
ERR43 B CURRENT
ERR50 ORIGIN
To Next Page
Loading...
