MIMAKI JFX500-2131 - Page 61

3-15
1
1
3
Convenient use
5
6
Setting UV mode
10
Press the key.
11
Press to set the level for the intensity of
the LED UV device.
Set Value : 1 to 10 (Default=5)
• The intensity is at maximum with the initial setting value of 10.
• Decreasing the level reduces the intensity.
12
Press the key.
13
Press the key several times to end the setting.
If you want to print using the UV lamp light control set
in this machine
1
Press the key in LOCAL.
2
Press the key.
3
Press to select [UV MODE].
4
Press the key.
5
Press to select [CONTROL].
6
Press the key.
• Depending on the level setting, a UV-related error, such as overheating, may occur. If an error occurs,
set the intensity to a lower level.
UV MODE
LEVEL : 10
UV MODE
LEVEL : 5
SETUP
UV MODE [ ENT ]
FUNCT I ON
SETUP [ ENT ]
SETUP
FEED COMP . [ ENT ]
SETUP
UV MODE [ ENT ]
UV MODE
:PATTERN
UV MODE
:CONTROL
UV MODE
UV CTRL AREA : FULL