Maintaining the Capping Station
4-5
1
1
1
4
Routine Maintenance
5
Remove the wiper.
• Pull out the wiper by holding the protrusions at its both ends.
6
Clean the wiper and bracket.
• Wipe off the ink sticking to the wiper and bracket with a
clean stick dipped in cleaning liquid for maintenance.
Wipe off so that cleaning solution for maintenance will not
remain.
7
Clean the wiper slider.
• Wipe off the ink sticking to the wiper slider with a clean stick
dipped in cleaning liquid for maintenance.
Wipe off so that cleaning solution for maintenance will not
remain.
8
Set the wiper at the original position.
• Insert the wiper by holding both ends of the wiper.
• Clean the wiper and bracket until it looks as shown in
the photo on the right.
• After cleaning, make sure that the bracket and wiper
are aligned horizontally.
To Next Page
Loading...
