4-6
9
Clean the wiper blade.
• Soak the clean stick in the maintenance cleaning liquid, and
then remove the ink that has adhered to the wiper blade.
10
Clean the cap rubber and cap rubber cover.
• Wipe off the ink sticking to the cap rubber and cap rubber
cover with a clean stick dipped in cleaning liquid for
maintenance.
Wipe off so that cleaning solution for maintenance will not
remain.
11
Press the key after the cleaning.
• After its initial operation, the machine returns to step1.
Performing the station maintenance without key
You can select station maintenance by using the key in the Local without pressing the key.
• Make sure to be careful with the edge of the
wiper blade, and thoroughly clean the side
(back side) where the wiper touches.
• Clean the wiper blade until it looks as shown
in the photo below.
• Clean the cap rubber and cap rubber cover until it looks as shown in
the photo on the right.
• Make sure that the cap rubber and mesh inside the cap have not
come off after cleaning.
Press the
key in Local.
Press to
select [MAINTENANCE].
Press the key twice.
• It becomes the same condition as the
key is pressed from Local.
To Next Page
Loading...
