MIMAKI JV5-160S - Page 193

5-23
Troubles for which error messages are displayed
∗∗∗∗ ERROR 163 ∗∗∗∗
NCU SENSOR
An error occurred in the control sys-
tem.
Operation can be resumed.
If the error occurs frequently, contact
your local distributor to call for ser-
vice.
∗∗∗∗ ERROR 163 ∗∗∗∗
NCU SENSOR DETECT
An error occurred in the control sys-
tem.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
Operation can be resumed after turning
off the nozzle missing detection func-
tion.
∗∗∗∗ ERROR 164 ∗∗∗∗
NCU FPGA ERROR
An error occurred in the control sys-
tem.
∗∗∗∗ ERROR 200 ∗∗∗∗
HEAD MEMORY (----)
An error occurred in the circuit board
system.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
∗∗∗∗ ERROR 201 ∗∗∗∗
BACKUP MEMORY
An error occurred in the circuit board
system.
∗∗∗∗ ERROR 201 ∗∗∗∗
BACKUP DATA
An error occurred in back-up data. The continued use is possible.
If the error message appears fre-
quently, please call for services.
∗∗∗∗ ERROR 202 ∗∗∗∗
DEVICE CONSTRUCTION
An error occurred in the control sys-
tem.
Contact your local distributor to call
for service.
Press the [ENTER] key to display the
details of the error. Press the [ENTER]
key again to enable the system to be
started after changing the configura-
tion to a supported one. (See 5-13)
∗∗∗∗ ERROR203 ∗∗∗∗
SDRAM SIZE
An error occurred in the control sys-
tem.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
(When there is available SDRAM
mounted, the printer operation can be
resumed without expanding SDRAM.
However, printing speed may drop
depending on the resolution.)
∗∗∗∗ ERROR 210 ∗∗∗∗
INTERLOCK SENSOR
An error occurred in the control sys-
tem.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
∗∗∗∗ ERROR 211 ∗∗∗∗
HeaterTEMP(--/--/--)
An abnormal temperature of the media
heater was detected.
Turn off the power to the printer and
turn it on after a while. If the same
error message appears again, contact
your local distributor to call for ser-
vice.
∗∗∗∗ ERROR 211 ∗∗∗∗
HeadWARM.TEMP.(----)
An abnormal temperature of the head
heater was detected.
∗∗∗∗ ERROR 211 ∗∗∗∗
HeadWARM.BREAK(----)
The head heater is disconnected.
∗∗∗∗ ERROR 211 ∗∗∗∗
HeadWARM.THERM(----)
Trouble has occurred with the ther-
mistor of the head heater.
Error message Cause Remedy