2 Before Use
2-22
Operation to set function menus
To set a function menu, press the [FUNCTION] key in LOCAL mode and press [], [], [] or [] or
[ENTER] key as appropriate. If the printer is not in LOCAL mode, press the [REMOTE] key once.
How to make setting
As an example of setting procedure, that for [SET UP] → [AUTO CLEANING] is described below.
STEPS:
1Make sure that the printer is in LOCAL mode.
If it is in REMOTE mode, press the [REMOTE] key.
2Press the [FUNCTION] key.
Once the following screen is displayed, press the [ENTER] key twice to go to the lower level of the hierarchy.
3Press the [] key 13 times to select [AUTO CLEANING], and press the [ENTER] key.
The menu screen will turn into the screen for setting ON/OFF of automatic cleaning.
When in REMOTE mode
13
times
To Next Page
Loading...
