A7™ Service Manual 046-006272-00 2 - 9
Installation Guide Assembly
FIGURE 2-13
16. Install the Breathing Assembly on the side of the A7. Align the Assembly carefully, and then push
it firmly towards the A7 until the Assembly clicks into place.
FIGURE 2-14
17. Carefully open the small box that contains the Bellows Assembly and Bellows Dome. Remove
the plastic bags from the Assembly. Place the foam pieces and plastic bags in the box.
18. Install the bellows on the Breathing System. Ensure that the bellows is stretched completely
around the lip on the breathing system when installed.
To Next Page
Loading...
