Mindray A9 Operating Instructions

Cleaning and Disinfection Maintenance
9 - 26 Operator’s Manual of Anesthesia System
Figure 9-33 Insert the O
2
sensor cable
5. Close the O
2
sensor cover. The O
2
sensor is now fully Installed.
9.7.3.4.9 Manual bag
Directly insert or draw out the manual bag to install or disassemble it.
Figure 9-34 Install the manual bag
9.7.3.4.10 Breathing Tube
NOTE: When installing a breathing tube, hold the joints at both ends of the
tube to prevent damage to the tube.
NOTE: Do not reuse the bacteria filter repeatedly to prevent cross infection.
NOTE: Install the filter following the instructions in this manual to prevent
dust or particles from entering the patient's lungs and prevent cross
infection.
CAUTION: The bacteria filter shall comply with the requirements of ISO 23328-1
and ISO 23328-2.
Oxygen sensor cable
Manual bag

Mindray A9 Specifications

General

Type	Anesthesia Workstation
Integrated Gas Analysis	Yes
Backup Battery	Yes
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to 55°C
Battery Type	Lithium-ion
Ventilation Modes	Volume Control, Pressure Control, SIMV, Manual Ventilation
Display	Touchscreen
Patient Monitoring	ECG, SpO2, NIBP, EtCO2, Temperature
Connectivity	Ethernet, USB
Portability	Mobile (with wheels)
Battery Life	Minimum 90 minutes (typical)
Altitude	Up to 3000 meters
Power Supply	100-240 VAC, 50/60 Hz
Charging Time	Approximately 4 hours
Storage	Internal storage for patient data and system logs
Supported Languages	Multiple languages
Certifications	CE, FDA