Customizing the Analyzer Software
5-9
Figure 5-13 Selecting baud rate
Selecting parity
To choose the “Odd”, “Even” or “None” (default) check, SELECT the desired check from the
“Parity” drop-down list, as Figure 5-14 shows.
Figure 5-14 Setting parity
Activating/deactivating handshake
If the “Handshake” function is activated, to start the transmission this analyzer will send a
handshake signal to an external computer and wait for the response. If the computer does not
respond, this analyzer will abort the transmission and give an alarm for the transmission error.
If the “Handshake” function is deactivated, this analyzer will transmit data to the external
computer regardless of the response. This function is deactivated by default.
To Next Page
Loading...
