5-64 Image Optimization
In image viewing status, you can perform all operations (except reset ROI) that can
be performed in Smart 3D. For details, please refer to “5.11.4.4 Smart 3D Image
Viewing”.
8. Return to image acquisition preparation:
Press <ESC>, <Update> or <Freeze> to return to image acquisition and perform
imaging again if necessary.
9. Exit 3D/4D.
Press<B>, 3D/4D shortcut key, or press <ESC> twice to exit Smart 3D imaging.
5.11.6.2 Static 3D Acquisition Preparation
Click [Static 3D] in the soft menu to enter the Static 3D acquisition preparation status.
Adjustable parameters in Static 3D acquisition preparation status are the same as that of
Smart 3D and 4D, for details, please refer to the corresponding contents in “Smart 3D”
and “4D”.
5.11.6.3 Static 3D Image Acquisition
Image acquisition operations are basically similar with that of 4D, the only difference is: in
Static 3D imaging, only a single frame 3D image is captured, while in 4D imaging,
continuous, high volume acquisition of 3D images are provided. The system enters Static
3D image viewing status when the acquisition is completed.
5.11.6.4 Static 3D Image Viewing
All functions (except ROI reset) in Smart 3D image viewing mode are available in Static
3D image viewing mode, for details; please refer to “5.11.4.4 Smart 3D Image Viewing”.
5.11.6.5 Static 3D Image Saving
For details, please refer to “5.11.4.5 Image Saving and Reviewing in Smart 3D”.
To Next Page
Loading...
Need help?
General
