4-8 Exam Preparation
4.3 Select an Exam Mode and Probe.
CAUTION:
If the exam mode is changed during a measurement, all
measurement calipers on the image will be cleared. The data
of general measurements will be lost, but the data of
application measurements will be stored in the reports.
4.3.1 Supported Exam Modes
The system can be configured with applications including abdominal, gynecology,
obstetrics, cardiac, vascular, small parts, urological, pediatrics, EM and nerve use, and the
system will support corresponding exam modes related to the application software (refer
to “2.5.2 Options” for details); the system also supports user-defined exam modes.
The system supports to preset application type, measurements, comments, body marks,
image parameters for each exam mode (including user-defined exam modes). For details,
please refer to “14.2 Exam Preset”.
You can select exam modes for the probes. For details, please refer to “14.2.1 Exam
Selection”.
4.3.2 Selecting Exam Modes and Probes
Select the exam mode(when connecting with one probe):
(1) Press <Exam> to open the following dialog box.
(2) Roll the trackball and press <Set> to select the exam mode.
To Next Page
Loading...
Need help?
General
