Exam Preparation 4-11
4.6.2 End an Exam
Before examining a new patient, press <End Exam> to end the exam of the previous
patient, update the patient ID and information, to avoid mixing data of the next new
patient.
To end an exam, you can do one of the following:
Press <End Exam> on the control panel.
Click [New Patient] on the Patient Info screen to end the last patient exam and
clear the patient information.
Click [New Exam] on the Patient Info screen (or iStation screen, or Review screen)
to end the last exam and clear the exam data.
4.7 Cancel an Exam
An undergoing exam can be stopped by clicking [Cancel Exam] in the Patient Info screen.
1.
Press <Patient>
to enter
"Patient In
fo" screen.
2. Click [Cancel Exam].
3. The system prompts the confirmation message, and requires to select the reason for
canceling the exam as the following figure:
4. Select the reason and click [OK].
5. After the above operations being taken, the exam is cancelled, and images,
measurements and report are saved with the status of the exam to be "Canceled".
If the system has been configured with a MPPS server, it will send the status
information "Cancelled" to the server. For details, please refer to relevant description
in the DICOM chapter.
To Next Page
Loading...
Need help?
General
