Chapter 6 Programming 6-83
<Figure 6-84 가 Speed setting window >
5. Parameter Setting (P)
- This function is used to set conveyor speed and Fiducial mark inspection and is not available
for customers (Used for a machine equipped with two gantries).
6. Feeder Check (C)
- Feeder status is displayed with a small icon providing feeder delete information for user.
7. Finish (F)
- This function is commonly used to cancel incomplete action of MCS in case of a software
error.
8. Communication Reset (M)
- Resets communication in case of an error.
9. Shut Down System
- Exits from the machine run program. Equivalent to GameOut on the MrTerminal.
10. Environment Setting (E)
- Set various parameters required for production.
To Next Page
Loading...
