Installation
164
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
Fig. 72 Assembly of the Bluetooth module
Warning
The system's reliability can be adversely affected by electrostatic discharges caused by touch-
ing electronic components and elements, and subsequent damage can result. Always observe
the ESD guidelines.
1. Fit foam spacers on the connector side of the Bluetooth module (for the position of
the foam spacer see ➀). The spacer ensures that the Bluetooth module sits se-
curely.
2. Carefully remove the cover for the Bluetooth module on the underside of the phone
using a suitable screwdriver (see ➁).
3. Connect the Bluetooth module. Make sure it is securely fitted (see ➂).
4. Fit the cover for the Bluetooth module back into place and press home until it snaps
into place (see ➃).
To Next Page
Loading...
