Mitel 470 - Access Enabled by Local Users; Function Code for Remote Maintenance Access

Configuration
186
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
5. 4. 1 Access enabled by local users
Remote maintenance access can be enabled in two ways:
• Using function codes (see page 186
)
• With WebAdmin
It can be revoked again automatically or manually.
All enabling types have equal authorization status. This means that remote mainte-
nance access can be enabled using a function code for example, and then barred
again using the WebAdmin in general maintenance settings ( =t0).
When remote maintenance access is activated, the event message Remote mainte-
nance on is sent to the local printer and to all the terminals registered in message
group 16.
If remote maintenance is released, this can be recognised in the WebAdmin title bar of
the symbol.
Remote maintenance access can be enabled or barred using the function codes both
from the idle state and the talk state, e.g. after an enquiry.
The authorisation to activate or bar remote maintenance access using the function
code is defined and granted to the user with the parameter Remote maintenance ac-
cess in a permission set ( =cb).
After a first start of the communication server, the authorizations of all users are re-
stricted.
Note:
It is advisable not to keep the remote maintenance access permanently activated. This ensures
that the communication server data cannot be manipulated from a remote location by unauthor-
ized persons.
5. 4. 2 Function code for remote maintenance access
Tab. 87 Function code for remote maintenance access
When remote maintenance access is enabled using function code *754, access will
automatically be barred again once the remote maintenance process has been com-
pleted. It is possible to bar remote maintenance manually using #754 before it is initi-
ated.
Remote maintenance access can be enabled permanently using the function code
*753. To bar access, the authorized user must enter the function code #753 manually.
Enable/bar a one-off remote maintenance access *754 / #754
Enable/bar a one-offpermanent maintenance access *753 / #753