Configuration
185
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
5. 3. 3 Password-free access
It is possible to activate on the front panel a function that enables via password-free,
local access via LAN with administration right User access control. This is useful for
example if all the passwords have been lost.
There is no password-free access for remote maintenance.
5. 3. 4 Automatic exit from the configuration
Access to the configuration is interrupted if no changes are made to a parameter value
or the navigation system is not used during a specific timeout.
5. 3. 5 Access log
An access log with 20 entries is drawn up for each user account so that the history of
accesses to the configuration can be tracked. Denied access attempts using erroneous
or incorrectly type passwords are also logged. The logs can be read by each user (au-
thorization level) Administrator in Expert mode required).
Retrieving the log data
The system monitors all the accesses and failed access attempts and saves them in
the file system of the communication server. These lists can be retrieved locally or re-
motely. ( =ez or =z3).
CLIP verification
If in the general maintenance settings ( =t0) of the parameter CLIP required is acti-
vated, remote maintenance is only possible if the retrieving party is using a CLIP. The
CLIP number is also recorded by the access log.
Entering the processes in the log
Each access attempt generates an entry in the corresponding list.
In case of remote maintenance an entry will not be generated if remote maintenance is
barred or if CLIP required is activated in the configuration and no CLIP is received.
5. 4 Remote access
With a remote maintenance access the user is authenticated using his user name and
password. The user account must also be assigned an authorization profile in which
the interface access Remote maintenance dial-up access is enabled. This also applies
to SRM (Secure IP Remote Management), secure IP remote management.
To Next Page
Loading...
