Operation and Maintenance
215
Mitel 470 as of R4.1
syd-0585/1.2 – R4.1 – 08.2016
Accept the new card.
→ The local settings are copied to the card.
Register the phone on the communication server.
→ The registration data is stored on the card.
→ Modifications on the local settings are henceforth also stored on the card.
Cordless phone is already registered:
Accept the new card.
→ The local settings are copied to the card.
→ The registration data is copied to the card and erased from the cordless phone
memory.
→ Modifications on the local settings are henceforth also stored on the card.
Behaviour after inserting a valid microSD card
After starting the cordless phone you will receive, in the start phase, a message inform-
ing you that a new card with a new ID has been detected.
Accept the card.
→ The cordless phone restarts.
→ The card's registration data and local settings are used.
→ The original data remains stored in the cordless phone and is reactivated once the
card is removed.
Copying local settings using a commercially available microSD card
This procedure is helpful if several cordless phones with the same local settings must
be preconfigured.
1. Carry out on a master cordless phone without microSD card the local settings you
want.
2. Switch off the master cordless phone, insert a commercially available microSD card
then restart the master cordless phone.
3. Confirm the information that the microSD card is invalid.
4. Select Menu - Settings - General - Administration - Diagnostics - File Mgmt. Device
then copy all user data to the microSD card.
-> The card is now specially marked as a copy card.
5. Switch off the master cordless phone, remove the card and insert the card in the tar-
get cordless phone to which the data must be copied.
6. Start the target cordless phone and confirm the information that the user data on the
card will be used.
To Next Page
Loading...
