Mitel 5212 - Using the Handset; Using the Speakerphone

Using the phone system 31Final
You can pull back a call that has been answered by a twinned target phone by
pressing the corresponding Line Appearance key. See “Twinned calls” on
page 53.
Using the handset
To answer your phone using the handset, follow these steps:
1 Lift the handset.
You have now answered the call. The LCD displays the caller’s number
and name (if known).
If you choose to ignore the incoming call and select a different line
appearance, the line appearance continues to flash but the phone stops
ringing.
2 To end the call while using the handset, choose one of the following:
• Press the END softkey.
• Replace the handset.
Using the speakerphone
To switch from the handset to the speakerphone during a call, follow these
steps:
1 Press the Speaker key on the 5020/5220 IP phone or the key on
the 5224 IP phone.
2 Replace the handset.
To end a call while using the speakerphone, choose one of the following:
• Press the END softkey.
• Press the Speaker key on the 5020/5220 IP phone or the key on
the 5224 IP phone.
Switching from speakerphone to handset
To switch from the speakerphone to the handset during a call, pick up the
handset.
To end the call while using the handset, choose one of the following:
321: Robin Jones
ANSWER
321: Robin Jones
TRANS CONF END