Mitel 5212 - Using a Headset; Connect and Configure the Headset

Using the phone system 91Final
Change handset volume on the Telematrix 3000
To change the volume of the sound you hear through the handset, follow
these steps:
1 Lift the handset.
2 Repeatedly press the Volume keys until the volume is at the level you
want.
3 Replace the handset.
Change speaker volume on the Telematrix 3000
To change the volume of the sound you hear through the speaker, follow
these steps:
1 Press the Speaker button.
2 Repeatedly press the Volume keys until the volume is at the level you
want.
Using a
headset
The Mitel 5020/5220 and 5224 IP phones support the use of specially
designed headsets made by Plantronics. The following headset types are
available:
• Monaural over-the ear
• Binaural over-the head with voice tube
• Binaural over the head with noise canceling microphone
Some headsets are all supplied with a control switch that can be used to mute
the microphone.
Connect and configure the headset
To connect the headset to the Mitel 5224 or 5020/5220 IP phone, follow these
steps:
1 Plug the headset into the headset jack on the back of the 5224/5220 set.
2 Remove the handset from the cradle. You can hook it over the top of the
set cradle.
3 Press the DIR softkey, then the QUIT softkey to take the phone to an on-
hook (or idle) state.