Mitel 5212 - Using the Telematrix 3000 Phone

76 Using the phone system
Final
The ring, handset, and speaker volumes return to their default settings if
the phone loses power.
Change ring volume on the 5212 IP phone
To change the ring volume on your phone, follow these steps:
1 From another phone, make a call to your extension.
2 While it is ringing, repeatedly press the keys until the ring volume
is at the level you want.
Change handset volume on 5212 IP phone
To change the volume of the sound you hear through the handset, follow
these steps:
1 Lift the handset. You will hear dialtone.
2 Repeatedly press the keys until the volume is at the level you
want.
3 Replace the handset.
Change speaker volume on 5212 IP phone
To change the volume of the sound you hear through the speaker, follow
these steps:
1 Press the Speaker button. You will hear dialtone.
2 Repeatedly press the keys until the volume is at the level you
want.
Using the
Telematrix
3000 phone
This section describes the Telematrix 3000 phones. To set up your new phone
service, see “Initial setup for Telematrix 3000 phone” on page 78. For a
description of your phone, see “Telematrix 3000 phone features” on page 77.
Other topics covered in this section are: