Mitel 5212 - Transfer Call on the 5212 Ip Phone

Using the phone system 73Final
The system places the call on hold at a park location. The park location is
displayed on your phone LCD screen:
You are no longer connected with the caller and your phone returns to the
idle state.
To retrieve a parked call, follow these steps:
1 From an idle phone, lift the handset.
This will select the next available Line Appearance. Select a memory key
programmed with the Park/Retrieve feature. The phone LCD screen
displays:
2 Enter the required park location using the phone keypad.
The system connects you with the caller who was on hold at the park
location. The LCD screen now displays the caller's name (if known) or
number.
To cancel the retrieval of the parked call, press the key.
If you enter a park location where there is no caller on hold, the phone
LCD will briefly display "No Parked Call".
There are nine park locations available (1 through 9). If all park locations
are in use when you try to park a call, the phone LCD will briefly display
"Park Locations Full" and the call will be placed on hold.
If the call is left parked for 30 seconds, the phone of the person who
parked the call will beep and the phone’s LCD will briefly display "Call
parked at: " with the park location number to remind you that the call has
not been retrieved.
Speaker on the 5212 IP phone
Using Speaker, you can turn the speakerphone on your phone on and off. To
use Speaker, press the key.
Transfer call on the 5212 IP phone
Using Transfer, you can transfer a call from one phone to another. To transfer
a call, follow these steps:
Parked at: 4
Park Location:
Robin Jones