Mitel 5212 - Park and Retrieve on the 5212 Ip Phone

72 Using the phone system
Final
• Press the One Touch Speed Dial key. This will select an available Line
Appearance and activate the speakerphone.
Page on the 5212 IP phone
Using Page, you can send a page to all of the phones at your site. The page is
broadcast through the speaker of each available phone. To use this feature,
you must have a memory key programmed as a Page key.
To page all of the phones at your site, follow these steps:
1 Select a memory key programmed with the Page feature.
Your phone LCD screen displays "Calling: Site Page" while the system
identifies the available phones at your site.
2 When the system is ready for you to begin your page, you will hear an
alert tone and the phone LCD screen displays the number of phones
being paged.
3 Speak into the handset or the speakerphone.
4 To end the page, you have the following options:
• Replace the handset if using the handset.
• Select the key if using the speakerphone.
A page is not broadcast on phones that are busy.
If you select Page while there is already a page in progress, the system
waits until the page in progress is completed before your page is started.
Your phone displays "Calling: Site Page" and you hear ringing while you
are waiting.
Park and retrieve on the 5212 IP phone
Using Park and Retrieve, you can put a call on hold at a park location so that
it can be retrieved from any other phone at your business. To use this feature,
a memory key must be programmed as a Park/Retrieve key.
To put a call on hold at a park location, follow these steps:
1 While on an active call, select a memory key programmed with the Park/
Retrieve feature.
Calling: Site Page
Paging: 7 of 10