Mitel 5212 - Making a Call on the Telematrix 3000; Answering a Second Call on the Telematrix 3000

Using the phone system 79Final
• Press the speaker key on the Telematrix 3000 phone.
You have now answered the call.
If you choose to ignore the incoming call and select a different line
appearance, the line appearance continues to flash, but the phone stops
ringing.
Using the Telematrix 3000 speakerphone
To switch from the handset to the speakerphone during a call, follow these
steps:
1 Press the speaker key on the Telematrix 3000 phone.
2 Replace the handset.
3 To end a call while using the speakerphone, press the speaker key on the
Telematrix 3000 phone.
Switch from speakerphone to handset on the Telematrix
3000
• To switch from the speakerphone to the handset during a call, pick up the
handset.
• To end the call while using the handset, replace the handset.
Answering a second call on the Telematrix 3000
A second incoming call causes the phone to ring once, and a line appearance
key to flash.
To answer a second call, choose one of the following:
• Press the flashing Line Appearance key. This puts the active call on hold
and answers the second call.
• End the first call by replacing the handset. The phone will start ringing.
Pick up the handset again to answer the second call.
• To switch between two active calls, press the flashing Line Appearance
key. This puts the active call on hold and activates the other call.
Making a call on the Telematrix 3000
To make a call, follow these steps:
1 Lift the handset. This will select the next available Line Appearance.