Mitel 5212 - Page 38

Using the phone system 33Final
2 To make an internal call, dial the extension. To make an external call, dial
the prefix required for external dialing (usually “9”) followed by the number
you want to call.
When you finish dialing, the number the call will be placed.
If you place an internal call, your LCD displays the extension and name of
the connected party once the call is answered. If you place an external
call, the LCD displays the name of the connected party, or if the name is
unknown, the phone number.
3 To end the call, choose one of the following:
• Press the END softkey.
• Replace the handset.
To use the speakerphone for step 1, press an available Line
Appearance key or the Speaker key on the 5020/5220 IP phone or the
key on the 5224 IP phone instead of lifting the handset.
4 To end a call before you have completed dialing, choose one of the
following:
• Replace the handset if using the handset.
• Select the Speaker key on the 5020/5220 IP phone or the key on
the 5224 IP phone.
• Press the End softkey.
Making a second call
To make a second call, while on an active call, follow these steps:
1 Press any available Line Appearance key. This puts the active call on
hold, and provides dial tone for a second call.
2 To make an internal call, dial the extension. To make an external call, dial
the prefix required for external dialing (usually “9”) followed by the number
you want to call.
3 When you finish dialing the number, the call will be placed.
320
Calling: Robin Jones
END
320: Robin Jones
TRANS CONF END
320