Mitel 5212 - Page 62

Using the phone system 57Final
If you choose to ignore the incoming call and select a different line
appearance, the line appearance continues to flash but the phone stops
ringing.
Using the 5212 speakerphone
To switch from the handset to the speakerphone during a call, follow these
steps:
1 Press the key on the 5212 IP phone.
2 Replace the handset.
3 To end a call while using the speakerphone, press the key on
the 5212 IP phone.
Switch from speakerphone to handset on the 5212 IP phone
To switch from the speakerphone to the handset during a call, pick up the
handset.
To end the call while using the handset, replace the handset.
Answering a second call on the 5212 IP phone
A second incoming call causes three things to happen: (1) the phone rings
once, (2) a line appearance flashes, and (3) the LCD displays the number and
the name of the caller, if the caller is known.
To answer a second call, choose one of the following:
• Press the flashing Line Appearance key. This puts the active call on hold
and answers the second call.
• End the first call by replacing the handset. The phone will start ringing.
Pick up the handset again to answer the second call.
To switch between two active calls, press the flashing Line Appearance key.
This puts the active call on hold, and activates the other call.
321: Robin Jones
))321: Robin Jones