270
13 SERIAL COMMUNICATION MODULE DEDICATED COMMANDS
13.5 Programmable controller CPU monitoring function
Data specified by request data
■Command
■Subcommand
■Cycle time units, cycle time
Specify the following time interval (period for 1 cycle). (Page 266 Cycle time)
• Time interval that C24 reads monitoring information from CPU module
• Transmission interval of monitoring result when 'fixed cycle send' is specified with the Programmable controller CPU
monitoring function
The time unit (100 ms/1 second/1 minute) can be selected. (Page 266 Cycle time units)
■Programmable controller CPU monitoring function
Specify the send timing (fixed cycle send/condition match send) of the monitoring result. (Page 266 Programmable
controller CPU monitoring function)
■Transmission method
Fixed '0'.
■Number of registered word blocks, number of registered bit blocks
Specify the number of blocks of word device registration and bit device registration. (Page 73 Number of blocks)
■CPU error monitoring, CPU error monitoring registration
Specify whether to perform error monitoring (status monitoring) of host station CPU module together. (Page 267 CPU
error monitoring, CPU status information)
• When do not perform CPU error monitoring (0): CPU error monitoring registration is not required.
• When perform CPU error monitoring (1): Register the following fixed values to CPU error monitoring registration.
ASCII code Binary code
ASCII code Binary code
ASCII code Binary code
ASCII code Binary code
010
30
H
31
H
30
H
0
30
H
000
30
H
30
H
30
H
000
30
H
30
H
30
H
1
31
H
0
30
H
0
30
H
0
30
H
0
30
H
1
31
H
5
35
H
0
30
H
0
30
H
0
30
H
00
H
00
H
00
H
01
H
01
H
00
H
05
H
00
H
01
H
00
H
To Next Page
Loading...
