Mitsubishi Electric MELSEC iQ-R Series - Page 277

13 SERIAL COMMUNICATION MODULE DEDICATED COMMANDS
13.5 Programmable controller CPU monitoring function
275
13
■Data communication in binary code
(Request data)
(Response data)
In the figure (1) and (2), set the value to "Binary code" in the tables of "Device data" of each response data.
The order of device data differ depending on the setting of "Word/byte units designation" in Engineering tool.
00 H 02 H 01 H 01 H 30 H 06 H 00 H 00 H 01 H 1E H 00 H 01 H
00 H 00 H 00 H A8 H 04 H 00 H 00 H 00 H
00 H 00 H
00 H 10 H 00 H B4 H 08 H 00 H 00 H 00 H
00 H 00 H
00 H 00 H 00 H 90 H 02 H 00 H 00 H 00 H
00 H 00 H
00 H 00 H 00 H 01 H 01 H 00 H 05 H 00 H 01 H 00 H
Cycle time unit
Programmable controller
CPU monitoring function
Number of registered word blocks
Subcommand
Transmission
method
Number of registered bit blocks
Cycle time CPU error monitoring
Word device registration (First point) Word device registration (Second point)
Number of
registered points
Monitoring
condition value
Number of
registered points
Monitoring
condition
Monitoring
condition value
Monitoring start
device
Monitoring start
device
D0 to D3 W100 to W107
Bit device registration (first point)
Number of
registered points
Monitoring
condition value
CPU error monitoring registration (Fixed value)
Monitoring start
device
M0 to M31
Monitoring
condition
Monitoring
condition
(1) (2)
02 H 01 H 01 H
21 H 02 H
01 H
00 H 00 H 00 H A8 H 04 H 00 H
00 H 00 H 00 H 90 H 02 H 00 H
00 H 00 H 00 H 01 H 01 H 00 H 01 H 00 H
00 H 00 H
Number of registered word blocks
Programmable
controller CPU
monitoring function
Number of registered bit blocks
CPU error monitoring
Word device registration
Bit device registration
Number of
registered
points
Number of
registered
points
Monitoring
start device
Device data
Device data
(First point)
(First point) (Second point)
CPU status information
Monitoring
start device