4-173 Detailed explanation of command words
4MELFA-BASIC IV
(6) If the specifications of numerical value 1 and numerical value 2 are different, continuous operation will be
performed at the position (distance) that is the smaller of these two.
(7) If numeric value 2 is omitted, the same value as numeric value 1 will be applied.
(8) When continuous operation is specified, the positioning completion specification by the Fine instruction
will be invalid.
(9) If the proximity distance (value 1, value 2) is set small, the movement time may become longer than in
the status where Cnt 0.
(10) Even when continuous operation is specified, acceleration/deceleration is performed for the interpola-
tion instruction that specifies singular point passage as the interpolation method.
To Next Page
Loading...
