Mitsubishi MELFA CR1D User Manual

5Functions set with parameters
About ROM operation/high-speed RAM operation function 5-388
[2] Execute a restore operation by manipulating the operation panel
[3] Change the parameter value and switch to the RAM operation.
Change the value of the ROMDRV parameter from 1 to 0.
After changing it, be sure to shut off the power, and turn it on
again.
START
STATUS NUMBER
STATUS NUMBER
STATUS NUMBER
STATUS NUMBER
STATUS NUMBER
STATUS NUMBER
Power ON
Approx. 8 sec.
Approx. 12 sec.
Approx. 8 sec.
STATUS NUMBER
Power ON
The completion of restoring into the RAM area
is displayed.
This display varies depending on whether or
not there is extension memory.
OK4: When standard memory is used
OK7: When 2 MB extension memory is used
* The time required to start up after the power
is turned on is almost the same as the normal
operation, which is different from when writing
to the ROM area.
Approx. 12 sec.
Press the [START] button on the operation panel.
"88888" is displayed in STATUS NUMBER just like
for normal operation.
Power ON at
normal operation
Power ON after a write
restoring into the ROM area
<PARAMETER> NAME(ROMDRV )
ELE( )
DATA
(0 )
CLOSE
123
Next
DATA
Prev
<PARAMETER> NAME(ROMDRV )
ELE( )
DATA
(1 )
CLOSE
123
Next
DATA
Prev

Mitsubishi MELFA CR1D Specifications

General

Brand	Mitsubishi
Model	MELFA CR1D
Category	Controller
Language	English