Sec 1: 8-8 Disassembly/Reassembly Procedures: Battery
8.5 Battery
This section explains how to properly attach and remove the battery.
NOTE: The Motorola-approved battery shipped with the APX 5000/ APX 6000/ APX 6000Li radio is
uncharged. Prior to using a new battery, charge it per the recommended procedure for the
battery.
8.5.1 Attach Battery
To attach the battery:
1. With the radio turned off, verify that the battery seal is set properly in its groove as shown in
Figure 8-6.
Figure 8-6. Attaching Battery – Battery Seal
To avoid a possible explosion:
• DO NOT charge, remove, or attach the battery in an area
labeled “hazardous atmosphere.”
• DO NOT discard batteries in a fire.
If the radio is programmed for volatile-key retention,
encryption keys will be retained for approximately 30 seconds
after battery removal.
To Next Page
Loading...
