Sec 2: 8-16 Disassembly/Reassembly Procedures: Radio Disassembly
Figure 8-20. Remove Flex Connectors and Expansion Board Assembly
5. Remove the Expansion Board Assembly (H) by gently lifting up the right side of the PCB as
shown in Figure 8-20.
6. If the VOCON Board Assembly (D) is to be removed from the radio, then unplug the Control
Top Assembly flex as shown in Figure 8-20.
7. If the RF Board Assembly (C) is to be removed, use the Black Stick to unplug the antenna
coax cable from the RF Board Assembly as shown in Figure 8-21.
Figure 8-21. Remove Antenna Coax Cable Connector
8. Flip the radio over.
Flex Connectors
Expansion Board Assembly (33)
Control Top Assembly Flex
Antenna Coax Cable Connector
To Next Page
Loading...
