June 2013 6878215A01
6-4 Finishing the Installation Miscellaneous Information
NOTE: Parts B and F require inserting then turning approximately 1/3 turn using a coin as a tool until
it contacts the stop.
Parts C and/or D shall be installed onto DB25 accessory cable assembly when the
corresponding cable assembly connections are not in use.
Part G is not used on single band transceivers.
6.3 Miscellaneous Information
On the mid power and 100W radios, there are rubber port plug which seals an opening which is used
for a future antenna connection. On the mid power, the port plug is located at the bottom of the radio
behind the control head or TIB. On the high power, the port plug is located at the TIB. These plugs
are critical to the sealing of the radio and should not be removed unless to replace it due to damage
or to install the future antenna connector. Removal of the port plug in any other situation would
create a leak path into the radio.
To Next Page
Loading...
Need help?
General