http://www.mcg.mot.com/literature IN-3
I
N
D
E
X
external battery, connecting 1-10
F
features
by model xv
general description 5-6
summary 5-5
firmware 3-1, 5-10
command buffer 4-4
delay 4-3
offset 4-3
size 4-3
command execution 3-3
command syntax 3-3
commands 3-3
memory requirements 3-2
overview 3-1
Flash memory 3-2, 5-10, 6-6
programming 3-6, 6-5
status LED 6-30
write protecting 6-5
floppy disk drive
connector (J17), pinouts 6-28
controller 5-15
power 5-15
forced air cooling A-3
freshness seal, breaking and resetting 5-11
functional description 5-1
fuses, self-resetting 5-20
H
handshaking, serial 1-7
hard disk drive
interface 5-19
EIDE connector (J14), pinouts 6-26
power 5-20
hardware
features xv, 5-5
handshaking 1-7
initialization 2-2, 5-14
Help command 3-3
humidity A-1
I
I/O controller 5-13
I
2
C (interprocessor-integrated
controller) 5-17
IDE addressing modes 6-9
IEEE 1149 test port
header (J23), pinouts 6-13
selection 6-7
signals 6-7
IEEE 1284 parallel port 5-14
header (J13), pinouts 6-14
initialization 2-2, 5-14
installation overview 1-1
installation procedures 1-1
installing
8xx/COMM module 1-7
DRAM 1-12
expansion modules 1-7
MBX board 1-3
PC/104 modules 1-7
PC/104-Plus modules 1-7
PCMCIA module 1-7
replacement battery 1-14
ISA arbitration 5-19
ISA connectors (J21/J22) 5-19
pinouts 6-25
J
J1 to J11
See jumpers.
J12 power connector, pinouts 6-12
J13 parallel I/O header, pinouts 6-14
J14 EIDE connector 5-19
pinouts 6-26
J15 10BaseT connector, pinouts 6-16
J16 utility connector #1, pinouts 6-21
J17 floppy disk connector, pinouts 6-28
J18 serial port header, pinouts 6-15
J19 utility connector #2, pinouts 6-29
J20 AUI header, pinouts 6-16
J21/J22 ISA connectors 5-19
pinouts 6-25
To Next Page
Loading...
