7 - 12 MC70 Integrator Guide
Figure 7-15
Prompt for Login at Dialog Box
If the EDA does not have the credentials, you are prompted to enter a username and password. If the EDA has
the credentials (previous entered via a login dialog box), it uses these credentials unless the caching options
require the EDA to prompt for new credentials. If you entered the credentials via the profile, the EDA does not
prompt for new credentials. Table 7-9 lists the caching options.
Entering credentials applies these credentials to a particular profile. Logging out clears all cached credentials.
Editing a profile clears all cached credentials for that profile.
The following authentication types have credential caching:
•
EAP TLS
•
PEAP
•
LEAP
•
TTLS.
Selecting the
At Time check box displays the Time Cache Options dialog box.
Figure 7-16
Time Cache Options Dialog Box
Table 7-9
Cache Options
Description
At Connect Select this option to prompt for credentials whenever the WCS tries to connect to a new
profile. Deselect this to use the cached credentials to authenticate. If the credentials are
not cached, you are prompted to enter credentials. This option only applies when logged
in.
On Resume Selecting this reauthenticates an authenticated user when a suspend/resume occurs.
Once reauthenticated, the user is prompted for credentials. If the user does not enter the
same credentials that were entered prior to the suspend/resume within three attempts, the
user is disconnected from the network. This option only applies when logged in.
At Time Select this option to perform a local verification on an authenticated user at a specified
time. The time can be an absolute time or a relative time from the authentication, and
should be in at least 5 minute intervals. Once the time has passed, the user is prompted
for credentials. If the user does not enter the correct credentials within three attempts, the
user is disconnected from the network. This option only applies when logged in.
To Next Page
Loading...
Need help?
General
