Motorola Mototrbo - Page 103

Figure 60: Installing Rx and Reference Cables
2 Assemble the corresponding lock washers onto the connectors. Using a 16 mm hex nut driver,
tighten the 16 mm hex nuts to 15 in-lb (1.7 N-m) on both connectors.
Figure 61: Assembling Lock Washers onto Connectors
3 Insert two rubber plugs (PN 3287533V01) into the corresponding holes shown in
Figure 62: Installing WLAN and GNSS Rubber Plugs on page 103.
Figure 62: Installing WLAN and GNSS Rubber Plugs
Chapter 11: SLR 5000 Series Maintenance and Disassembly/Reassembly
Motorola Solutions Confidential
Send Feedback 103