MTS Systems FlexTest SE Service Information

Calibrating a Force Sensor
Model 493.02 Controller Service
Calibration
151
13. Record conditioner feedback readings at predetermined
compressive force command points.
Stand-Alone:
A. Use the Dial to adjust the Setpoint for a +2% compressive
force command.
B. Record the force standard’s readout value and corresponding
conditioner feedback reading in the +2% row of your record
sheet.
C. Repeat steps A and B for other compressive force commands
(typically at +4, +6, +8, +10, +20, +40, +70, and +100 percent
of full scale).
Automated:
A. Adjust the Manual Cmd slider for a +2% compressive force
command.
B. Record the force standard readout signal and corresponding
conditioner feedback reading at the +2% command line of
your record sheet.
C. Repeat steps A and B for other compressive force commands
(typically at +4, +6, +8, +10, +20, +40, +70, and +100 percent
of full scale).
14. Turn off system hydraulics.
15. On the Linearization Data window, enter the force standard values
and corresponding conditioner feedback readings for all
command points previously recorded on a separate sheet.
16. Turn on system hydraulics.
17. Verify linearization data.
Stand-Alone:
A. Using the Dial, adjust the Setpoint for each tensile and
compressive force command point on the Linearization Data
window.
B. At each command point, verify both the force standard value
(Standard) and its corresponding conditioner feedback value
(Conditioner).

MTS Systems FlexTest SE Specifications

General

Brand	MTS Systems
Model	FlexTest SE
Category	Controller
Language	English