Shutdown, transport, storage
Transporting the machine
112 10.06.2014
¾ Shut down the machine.
¾ Use suitable and adequately sized load lifting equipment. Note
here the machine dimensions and weight, see the shipping docu-
ments.
¾ Set the forklift to the widest setting.
¾ Position the load lifting equipment along the longer side of the
machine.
¾ While doing so establish the machine's centre of gravity. It can
lie outside the centre point of the machine.
¾ Secure the machine on the load lifting equipment against tilting
and falling over by using technically risk free transportation safety
attachments.
DANGER
Injury hazard!
Incorrect transport can cause the machine to fall or tip over.
Standing in the danger zone can lead to serious injuries or even
death.
¾ Do NOT stand under suspended loads.
¾ Lift the machine only at the designated points.
¾ Bear in mind the machine weight.
NOTICE Danger of material damage!
Incorrect transport can damage the machine.
Damage can cause faults in the machine, which in turn can result in
reject packs.
¾ Transport the machine centred on the forks.
NOTICE Danger of material damage!
At an inclination of more than 15°, the oil in the vacuum pump
shifts.
The air de-oiling elements will get wet from the oil and become inef-
fective. This will damage the vacuum pump.
¾ Transport and set the machine down as horizontally as possi-
ble.
¾ Do NOT tilt the machine.
¾ Lift the machine and transport it.
To Next Page
Loading...
