Start-up
Connecting inert gas
10.06.2014 53
3.5 Connecting inert gas
DANGER
Danger of explosion!
Gas mixtures with oxygen proportions over 21% are explosive.
A gas mixture with an oxygen proportion over 21 % can cause an
explosion and fire if it comes in contact with heat, oil or grease.
¾ Do NOT use a gas mixture with an oxygen proportion of over
21%.
DANGER
Risk of death!
During the packing process, inert gases are released.
Inhaling inert gas can impair your breathing. Over a longer period of
time, this can be fatal.
¾ A surface area of at least 40 square meters per machine must
be made available.
¾ Ventilate the rooms sufficiently and avoid any accumulation of
gas.
¾ Observe the maximum input pressure, see 'Technical specifica-
tions'.
¾ Cut off the gas supply at the end of work.
¾ Adhere to the safety regulations in effect in the country where
the machine is used.
Info
Observe the minimum and maximum permitted input pressure, see
“Technical specifications”.
¾ Attach a stop-cock to the gas supply on the operating side.
¾ Attach the gas hose to the inert gas connection of the machine.
¾ Fasten the hose with hose clamps.
¾ Open the stop-cock for the gas supply.
¾ Set the input pressure; see the section technical specifications.
3.6 Cleaning the machine (basic cleaning)
¾ After putting the machine into service carry out an intensive clean-
ing of the machine, see Section 6 "CLEANING".
Info
The machine is only to be used for production after a basic clean-
ing.
To Next Page
Loading...
