multivac C300 - Entering Basic Settings; Modifying and Resetting Machine Cycles; Display Production Data; Display Total Cycles of the Machine

Operation
Setting the sealing
64 10.06.2014
¾ Call up the "basic settings" menu.
¾ Set Fill diaphragm.
– Compressed air is admitted to the sealing diaphragm; this way
the sealing bar is pressed against the counter-pressure bar.
– If the chosen value is too low, the necessary sealing pressure
is not reached and the seal seam can be unsatisfactory.
¾ Set Ventilate diaphragm.
– After the sealing and after the sealing time has elapsed, the
sealing diaphragm is ventilated and thus slackened.
4.11 Entering basic settings
¾ Call up the "settings" menu.
¾ Call up the "basic settings" menu.
¾ Set the vacuum pump running-on time.
¾ Set Fill diaphragm.
¾ Set Ventilate diaphragm.
4.12 Modifying and resetting machine cycles
¾ Call up the "operating data" menu.
¾ Call up "Counter" menu.
¾ Call up machine cycles.
¾ Set the value with the <arrow> keys or set to "0".
– The set value is adopted.
4.13 Display production data
4.13.1 Display total cycles of the machine
¾ Call up the "operating data" menu.
¾ Call up "Counter" menu.
¾ Select Total cycles.