EasyManua.ls Logo

multivac C300 - Page 46

multivac C300
140 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Start-up
Initial start-up
46 10.06.2014
¾ Secure the machine on the load lifting equipment against tilting
and falling over by using technically risk free transportation safety
attachments.
DANGER
Injury hazard!
Incorrect transport can cause the machine to fall or tip over.
Standing in the danger zone can lead to serious injuries or even
death.
¾ Do NOT stand under suspended loads.
¾ Lift the machine only at the designated points.
¾ Bear in mind the machine weight.
NOTICE Danger of material damage!
At an inclination of more than 15°, the oil in the vacuum pump
shifts.
The air de-oiling elements will get wet from the oil and become inef-
fective. This will damage the vacuum pump.
¾ Transport and set the machine down as horizontally as possi-
ble.
¾ Do NOT tilt the machine.
¾ Lift the machine until the wooden base is free.
¾ Remove the wooden base below the machine.
DANGER
Danger of explosion!
Operating the machine in a potentially explosive atmosphere can
result in explosion due to hot machine parts.
Explosions can cause serious injuries or even death.
¾ Do NOT use the machine in rooms that are exposed to explo-
sion hazards.
¾ Take into consideration the installation and environmental condi-
tions at the location for the machine, see Technical Data.
¾ Transport the machine to the desired location.
¾ Set the machine down carefully.
¾ If the machine has swivel castors: Fix the machine in place by
locking the swivel castors.

Table of Contents

Related product manuals