Start-up
Initial start-up
48 10.06.2014
max.
min.
¾ Check the oil level on the oil sight glass.
– The oil level should reach the middle of the oil sight glass.
– If oil level is under the MIN mark, add oil.
¾ With an internal vacuum pump fasten the safety guard.
Adding oil
Fig. 42: Design of vacuum pump
1
Screw plug of fill opening
2
Oil sight glass
3
Screw plug of drain opening
¾ Switch off the machine.
¾ Disconnect the machine from the mains electricity.
To Next Page
Loading...
