Muratec MFX-C2280 Fax Guide

Description of Setup Buttons 9-23
9
[Line Setting]
To display: [Scan/Fax] - [Application] - [Fax Setting] - [Line Setting]
Specify how to send a fax based on the line conditions.
[Quick Memory TX]
To display: [Scan/Fax] - [Application] - [Fax Setting] - [Quick Memory TX]
As one page is scanned, fax transmission starts. Generally, transmission begins after all pages have been
scanned and saved in memory (Memory TX). With Quick Memory TX, many pages can be faxed without caus-
ing memory overflow.
Settings Description
[TX Method] Change the communication mode based on the line conditions.
• [Overseas TX]: Select this option to send a fax to areas where commu-
nication conditions are poor. Faxes are sent at a lower speed.
• [ECM]: Generally, faxes are sent while checking that the fax data is free
of errors by using ECM (Error Correction Mode). To reduce the time re-
quired to send a fax, cancel the setting.
• [V.34]: Generally, faxes are sent in the Super G3 mode. If it is not pos-
sible to send faxes in the Super G3 mode, cancel the setting.
[Check Dest. and Send] Select this option to use the Check Dest. And Send function.
The fax number specified for fax is checked against the remote fax number
(CSI) and the fax is only sent when they match.
[Select Line] If two lines are used, select the line used to send a fax.
If [No Selection] is selected, either line, whichever is not busy, is used for
transmission.

Muratec MFX-C2280 Specifications

General

Brand	Muratec
Model	MFX-C2280
Category	Copier
Language	English