Description of Setup Buttons (Administrator Settings) 11-23
11
[No. of Sets (RX)]
To display: [Utility] - [Administrator Settings] - [Fax Settings] - [TX/RX Settings] - [No. of Sets (RX)]
If necessary, change the number of copies to print a fax.
[1] is selected by default.
[Individual Receiving Line Setup]
To display: [Utility] - [Administrator Settings] - [Fax Settings] - [TX/RX Settings] - [Individual Receiving Line
Setup]
Select whether to receive faxes via respective lines separately if two lines are operating.
In receiving faxes per line, you can use reception functions, such as TSI Routing and Forward TX.
[OFF] is specified by default.
[Individual Sender Line Setup]
To display: [Utility] - [Administrator Settings] - [Fax Settings] - [TX/RX Settings] - [Individual Sender Line Set-
up]
Select whether to use different sender names for the respective lines if two lines are operating.
[OFF] is specified by default.
[Function Settings]
To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings]
Configure the settings for using various fax transmission and reception functions.
[Function ON/OFF Setting]
To display: [Utility] - [Administrator Settings] - [Fax Settings] - [Function Settings] - [Function ON/OFF Setting]
Enable or disable fax transmission and reception functions, such as Confirm Address that prevents wrong
fax transmission, F-Code TX, and Relay RX.
Settings Description
[Function ON/OFF Setting] Enable or disable fax transmission and reception functions, such as Con-
firm Address that prevents wrong fax transmission, F-Code TX, and Relay
RX.
For details on settings, refer to page 11-23.
[Memory RX Setting] Configure the settings for using the Memory RX function.
For details on settings, refer to page 11-26.
[Closed Network RX] Configure the settings for using the Closed Network RX function.
For details on settings, refer to page 11-26.
[Forward TX Setting] Configure the settings for using the Forward TX function.
For details on settings, refer to page 11-26.
[Incomplete TX Hold] Configure the settings for using the Fax Retransmit function.
For details on settings, refer to page 11-27.
[PC-Fax Permission Set-
ting]
Select whether to allow PC-Fax TX using the fax driver.
For details on settings, refer to page 11-27.
[PC-Fax RX Setting] Configure the settings for using the PC-Fax RX function.
For details on settings, refer to page 11-27.
[TSI User Box Setting] Configure the settings for using the TSI Routing function.
For details on settings, refer to page 11-27.
Settings Description
[F-Code TX] Select whether to use the F-Code TX function.
F-Code TX is a function that sends documents to a destination by entering
a SUB address and a sender ID (communication password) of a specific
user box. The remote machine must support the F-Code TX/RX.
For details on settings, refer to page 11-24.
To Next Page
Loading...
Need help?
General
