Section 75 00-02-0878
2013-03-07 - 97 -
The main purpose of M-Logic is to give the operator/designer more flexible possibilities
of operating the generator control system.
NOTE: Please refer to appendix for more details about this tool
available in the PC Utility Software (USW).
Buzzer
EMS-GC10 unit has a built-in buzzer. The buzzer is configured in M-Logic. This means
that if the buzzer is going to be used as a horn annunciator, the input must be set to
"Horn" and the output must be set to "Buzzer". The buzzer will act concurrently to the
horn output timer. If the delay timer in M-Logic is used, the buzzer will be active after
this time delay.
GSM Communication
The GSM modem communication is used to send a GSM message to up to five cellular
telephones when an alarm appears on the display.
System single-line diagram
NOTE: MOXA OnCell G2150I, Wavecom WMOD2 or Westermo
GDW-11 terminal are recommended as Modems, as the
application has been tested with these terminals.
To Next Page
Loading...
